12730 commonwealth drive ? fort myers, florida 33913 phone: 239-561-3311 ? 800-237-3061 fax: 239-561-1025 ? www.crystek.com crystek corporation microwave a division of crystek corporation notes: 1.0 materials 1.1 body, coupling, and cl amp nuts: steel. corrosi on resistant per astm-a582. uns no. s30300. 1.2 center conductor: beryllium copper per astm-b196. uns c17300. 1.3 solder ferrule: bra ss per astm-b16. uns c36000. 1.4 lock ring: be ryllium copper per as tm-b197. uns c17200. 1.5 gasket: silic one rubber per a-a-59588. 1.6 insulator: ptfe fluorocarbon pe r astm-d1710. 1.7 cable stop: polyet herimide thermoplastic (ult em 1000) per astm-d5205. 2.0 finishes 2.1 center contact and solder fe rrule: gold plate per astm-b488 50 microi nches min. thickness over electrolytic nickel plate per astm-b 689 50 microinches min. thickness. 2.2 body, coupling, and clamp nuts: passi vated per sae-ams-2700. 2.3 gasket, lock ring, an d dielectrics: none. 3.0 interface: type n plug per cryst ek interface specif ication cc-pnp-tl. note: distance from end of cable center conductor to ref. pl is 0.735 page 1 of 2
12730 commonwealth drive ? fort myers, florida 33913 phone: 239-561-3311 ? 800-237-3061 fax: 239-561-1025 ? www.crystek.com crystek corporation microwave a division of crystek corporation product control: crystek part number: revision level: release date: responsible: a k. piotrowicz 04-jan-11 CS-NM-MSD 1.1 trim cable as shown. step 1 2.1 slide clamp nut over cable as shown. 2.2 insert cable into so lder ferrule until cable di electric is flush with solder face of ferrule. 2.3 solder both cable braids where shown. 2.4 slide dielectric stop over cable center conductor and solder contact flush against stop to dimension shown. step 2 3.1 insert forward in sulator into connector in orientation shown. 3.2 insert cable/contact sub- assembly into connector until seated and tighten clamp nut to 35-45 in-lbs. step 3 page 2 of 2
|
